Adsorber MS-R
The MS-R stainless steel adsorber is made entirely of A4 stainless steel. With a filling capacity of 50kg desiccant up to 20l water from the air and thus has a long maintenance interval. Thus, large storage tanks can be ventilated efficiently, even in offshore applications.
Use in accordance with ATEX product directive 2014/34/EU in zone II 2 G / D IIC T4 is possible, as is use in accordance with corrosivity category C5-M. The loaded silica gel can be quickly removed and replaced by fresh gel through two large openings. In combination with a venting system and a supply air valve, the air flow into and out of a tank can be specifically controlled.
Due to the optimized design, these adsorbers can be maintained very quickly and economically. The wearing parts or the pure desiccant are quickly used and the protection of the plant to be ventilated is restored.
Downloads
Videos
Applications
 |
| Storage tanks |
BUILD UP AND ADDED VALUE
METHOD OF OPERATION
TECHNICAL DATA
This adsorber is available with and without an inlet valve. In the valve-free version, the sucked-in air flows into the adsorber almost without pressure. After flowing into the adsorber, the air is distributed evenly over the cross-section. The valve version has a somewhat higher differential pressure and is used in combination with a venting system.
When the desiccant silica gel flows through the adsorber, the water molecules are reliably removed from the air. The gap volume of the granules is optimally selected with 2 to 5mm grains. This guarantees a minimum pressure build-up and at the same time very good drying efficiency. Thus, at the beginning of the drying process, a residual air humidity of max. 2 % rH and a dew point of -40 °C are achieved. Due to the water absorption, the silica gel in the standard changes color from orange to green, indicating the end of the product life cycle.
This adsorber is made of A4 stainless steel, silica gel orange and FKM seals and will be used to aerate oils and lubricants, fuels, isocyanates, chemicals and solvents in large storage tanks. Please do not hesitate to contact the GIEBEL team for clarification of resistance.
PRESSURE DIFFERENCE
EXECUTIONS - ADSORBER MS-R
|
|
 |
 |
|
Adsorber |
MS-R 35L (without valve) |
MS-R 35L (with valve |
|
Total weight [kg] |
86,3 |
86,7 |
|
Adsorbens [kg] |
50,0 |
50,0 |
|
Max. water absorption [ml] |
20,0 |
20,0 |
|
Height [mm] |
1105 |
1105 |
|
Diameter [mm] |
356/420 |
356/420 |
|
Connection |
BSP G2" |
|
|
Valves [IN - OUT] |
0 - 0 |
1 - 0 |
